[CH:1]([C:6]1[C:14]2[C:9](=[CH:10][CH:11]=[CH:12][CH:13]=2)[CH2:8][CH:7]=1)=[CH:2][CH2:3][CH2:4][CH3:5].C([Li])CCC.[Cl:20][B:21](Cl)[N:22]([CH:26]([CH3:28])[CH3:27])[CH:23]([CH3:25])[CH3:24]>C(OCC)C>[Cl:20][B:21]([N:22]([CH:26]([CH3:28])[CH3:27])[CH:23]([CH3:25])[CH3:24])[CH:8]1[C:9]2[C:14](=[CH:13][CH:12]=[CH:11][CH:10]=2)[C:6]([CH:1]=[CH:2][CH2:3][CH2:4][CH3:5])=[CH:7]1Metallocene MET-1, shown below, was synthesized by first reacting lithiated indene with 5-bromo-1-pentene. Pure 3-(1-pentenyl) indene was obtained via vacuum distillation as a pale yellow oil. One mole of 3-(1-pentenyl) indene was added to diethyl ether and cooled to −74° C., and one mole of n-butyllithium was added. The reaction mixture was stirred at 21° C. for 3 hr, then cooled again to −74° C., followed by the addition of a diethyl ether solution of dichloro(diisopropylamino) boron, and then stirred for 12 hr while warming to 21° C. The resulting yellow slurry was centrifuged, and the bright yellow solution was poured off and solvent removed under reduced pressure. Monochloro(diisopropylamino)-3-(1-pentenyl)indenylboron was obtained as a yellow oil. 1 mol of indene was added to diethyl ether and cooled to −74° C., then n-butyllithium was added and the solution was stirred at 20° C. for 3 hr. The solution was cooled to −74° C. and a diethyl ether solution of monochloro(diisopropylamino)-3-(1-pentenyl)indenylboron was added, resulting in an orange slurry, which was stirred at 20° C. for 12 hr. The reaction solution was filtered into a Schlenk-tube and the solvent was removed under reduced pressure, yielding Ligand-1 shown below.
Wird geladen…
