Br[C:2]1[C:3](Cl)=[N:4][CH:5]=[N:6][C:7]=1Cl.[C:10]1(B(O)O)[CH:15]=[CH:14][CH:13]=[CH:12][CH:11]=1.C(=O)([O-])[O-].[Na+].[Na+]>C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.C1C=CC(P(C2C=CC=CC=2)C2C=CC=CC=2)=CC=1.Cl[Pd]Cl.C(#N)C.O>[C:10]1([C:3]2[C:2]([C:10]3[CH:15]=[CH:14][CH:13]=[CH:12][CH:11]=3)=[C:7]([C:10]3[CH:15]=[CH:14][CH:13]=[CH:12][CH:11]=3)[N:6]=[CH:5][N:4]=2)[CH:15]=[CH:14][CH:13]=[CH:12][CH:11]=1First, into a recovery flask equipped with a reflux pipe were put 4.25 g of 5-bromo-4,6-dichloropyrimidine, 6.84 g of phenylboronic acid, 5.95 g of sodium carbonate, 0.16 g of bis(triphenylphosphine)palladium(II)dichloride (abbreviation: Pd(PPh3)2Cl2), 20 mL of water, and 20 mL of acetonitrile, and the air in the flask was replaced with argon. This reaction container was heated by irradiation with microwaves (2.45 GHz, 100 W) for 60 minutes. Here, into the flask were further put 2.28 g of phenylboronic acid, 1.98 g of sodium carbonate, 0.053 g of Pd(PPh3)2Cl2, 5 mL of water, and 5 mL of acetonitrile, and the mixture was heated again by irradiation with microwaves (2.45 GHz, 100 W) for 60 minutes. After that, the precipitated solid was suction-filtered and washed with water. The obtained residue was purified by flash column chromatography using dichloromethane and ethyl acetate as a developing solvent in a ratio of 10:1, so that a pyrimidine derivative Htppm, which was the objective substance, was obtained (white powder, yield of 46%). Note that the irradiation with microwaves was performed using a microwave synthesis system (Discover, manufactured by CEM Corporation). A synthesis scheme (1-1) of Step 1 is shown below.