홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Sodium Hydroxide → HCID 85692231, 화합물

HRID 1109713
인쇄

반응식

HRID 1109713 반응식
[C:1]1([C:25]([CH2:27][CH2:28][C:29]([OH:31])=[O:30])=O)[C:18]2[C:19]3[C:24]4[C:3](=[CH:4][CH:5]=[C:6]5[C:23]=4[C:22]4[C:9](=[CH:10][CH:11]=[C:12]6[C:21]=4[C:20]=3[C:15](=[CH:16][CH:17]=2)[CH:14]=[CH:13]6)[CH:8]=[CH:7]5)[CH:2]=1.[OH-].[Na+]>C(O)COCCO>[C:1]1([CH2:25][CH2:27][CH2:28][C:29]([OH:31])=[O:30])[C:18]2[C:19]3[C:24]4[C:3](=[CH:4][CH:5]=[C:6]5[C:23]=4[C:22]4[C:9](=[CH:10][CH:11]=[C:12]6[C:21]=4[C:20]=3[C:15](=[CH:16][CH:17]=2)[CH:14]=[CH:13]6)[CH:8]=[CH:7]5)[CH:2]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

4

반응물 2

HCID 14798Sodium HydroxideHCID 54489600gamma-Oxo-4-(coronen-1-yl)butanoic acid

생성물 1

HCID 85692231HCID 85692231, 화합물수율 86%

시약·촉매·용매 1

HCID 8117Diethylene Glycol용매

반응 조건

온도
180 °C

실험 절차

The Huang-Minlon method was used essentially as described in Clar and Zanders (1958), with modifications to increase the overall yield of the acid: 3-coronenoyl propionic acid (100mg), 80% hydrated hydrazine (74.8 μl), NaOH (60mg), and diethylene glycol (249μl) were combined in a 5ml round-bottomed flask. The mixture was refluxed for 90 minutes at 180° C, then water and excess hydrazine hydrate were distilled off until the temperature rose to 200° C. The mixture was refluxed for an additional 3.5 hours at 195° C., cooled to room temperature and diluted with water and 2M HCl. The resulting solid was collected by vacuum filtration and washed with cold water and 2M HCl. The product was recrystallized from xylene, dried under vacuum for 48 hours. 50mg of crystalline product was further purified by flash chromatography on a silica gel G column (100cm×2.5cm; 40 micron particle size) with a nitrogen pressure of 5-10 p.s.i. using ethyl acetate/xylene (2:1; v/v) as the running solvent. The eluant was tested using TLC (silica gel G plates) and THF/xylene (1:1; v/v) as the running solvent. The pure 4-coronenyl butyric acid (FIG. 1, compound III) exhibited a single spot (Rf=0.65) under these conditions. Fractions containing pure product were pooled and dried by rotary evaporation. A yield of 86% was obtained (66.4 mg) with a melting point of 273° C. IR and NMR analysis showed spectra consistent with the expected product. Compound III in THF had an absorption band ε294 =23,644±97 80M-1 cm-1.

후처리

  1. temperatureto increase the overall yield of the acid
  2. distillationwater and excess hydrazine hydrate were distilled off until the temperature
  3. customrose to 200° C
  4. temperatureThe mixture was refluxed for an additional 3.5 hours at 195° C.
  5. temperaturecooled to room temperature
  6. additiondiluted with water and 2M HCl
  7. filtrationThe resulting solid was collected by vacuum filtration
  8. washwashed with cold water and 2M HCl
  9. customThe product was recrystallized from xylene
  10. customdried under vacuum for 48 hours
  11. custom50mg of crystalline product was further purified by flash chromatography on a silica gel G column (100cm×2.5cm; 40 micron particle size) with a nitrogen pressure of 5-10 p.s.i
  12. additionFractions containing pure product
  13. customdried by rotary evaporation
  14. customA yield of 86% was obtained (66.4 mg) with a melting point of 273° C

출처 및 근거

ORD 기록
ord-8ab430fe835843aab24614f7c5a09974
출처 데이터셋
uspto-grants-1994_06
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05322794

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트