홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Ethanol → 4-hydroxymethylene-dihydro-2,2,5,5-tetramethyl-3(2H)-furanone

HRID 1195627
인쇄

반응식

HRID 1195627 반응식
[CH3:1][C:2]1([CH3:10])[C:6](=[O:7])[CH2:5][C:4]([CH3:9])([CH3:8])[O:3]1.[H-].[Na+].[CH2:13]([OH:15])C.C(OCC)=O>CCOCC.O>[OH:15][CH:13]=[C:5]1[C:4]([CH3:9])([CH3:8])[O:3][C:2]([CH3:10])([CH3:1])[C:6]1=[O:7]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 4

HCID 702EthanolHCID 8025Ethyl formateHCID 24758Sodium hydrideHCID 1385112,2,5,5-Tetramethyltetrahydro-3-ketofuran

생성물 1

HCID 675748794-hydroxymethylene-dihydro-2,2,5,5-tetramethyl-3(2H)-furanone수율 79%

시약·촉매·용매 3

HCID 3283Diethyl Ether
촉매
HCID 962Water용매
HCID 3283Diethyl Ether용매

반응 조건

온도
0 °C

실험 절차

Mercuric oxide (600 mg) was dissolved in 200 mL of water containing 2 mL of concentrated H2SO4. Solid 2,5-dimethyl-3-hexyne-2,5-diol (50.0g, 352 mmol) was added and the solution was heated until the homogeneous solution turned cloudy. Heating was stopped and the flask was stirred in a room temperature water bath for 30 min. The solution was distilled and 250 mL of distillate was collected (more H2O was added). The biphasic material was taken up into ether, separated, washed with brine, dried over MgSO4, filtered, evaporated and distilled (150° C.) to give 44.5 g (89%) of dihydro-2,2,5,5-tetramethyl-3(2H)-furanone as a water-white oil. Dihydro-2,2,5,5-tetramethyl-3(2H)furanone (32.1 g, 226 mmol) in 50 mL of ether was added dropwise to a suspension of sodium hydride (18.1 g of 60%, 453 mmol) in 400 mL of ether containing two drops of ethanol and 36.5 mL (453 mmol) of ethyl formate stirred at 0° C. After stirring overnight at room temperature, the reaction mixture was taken up into water, washed with additional ether, acidified with 6N HCl and extracted into ether. The combined ether layers were washed with water and brine, dried over MgSO4, decolorized with charcoal, filtered through celite and evaporated. The solid residue was recrystallized from a small volume of ether and a large quantity of hexanes. The solid was isolated by filtration and dried to give 30.4 g (79%) of 4-hydroxymethylene-dihydro-2,2,5,5-tetramethyl-3(2H)-furanone as an off-white solid. Ethylenediamine (1.15 mL, 17.4 mmol) was added to a solution of 4-hydroxymethylene-dihydro-2,2,5,5-tetramethyl-3(2H)furanone (5.9 g, 34.7 mmol) in 40 mL of THF. This solution was refluxed for one hour. The solvents were evaporated under high vacuum with moderate heating. The solid residue was slurried in 50 mL of cold ether and filtered to give 5.3 g (76%) of off-white solid. Recrystallization from 50 mL of THF followed by drying at 70° C. (1 Torr) for 6 hours gave 4.0 g of 1,2-bis[dihydro-2,2,5,5-tetramethyl3(2H)furanone-4-methyleneamino]ethane as a white solid: Anal. Calc'd for C20H32N2O4 : C, 65.93; H, 8.79; N, 7.69. Found: C, 65.68; H, 8.90; N, 7.65.

후처리

  1. stirringAfter stirring overnight at room temperature
  2. washwashed with additional ether
  3. extractionextracted into ether
  4. washThe combined ether layers were washed with water and brine
  5. dry with materialdried over MgSO4
  6. filtrationfiltered through celite
  7. customevaporated
  8. customThe solid residue was recrystallized from a small volume of ether
  9. customThe solid was isolated by filtration
  10. customdried

출처 및 근거

ORD 기록
ord-efce0ca1b62241a1bbb06b4211651dc4
출처 데이터셋
uspto-grants-1992_05
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05112595

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트