홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Hydrochloric Acid → 4-Cyano-2-ethylbenzaldehyde oxime

HRID 1956708
인쇄

반응식

HRID 1956708 반응식
C=O.Cl.NO.O.O.O.C([O-])(=O)C.[Na+].S([O-])([O-])=O.[Na+].[Na+].N[C:21]1[CH:28]=[CH:27][C:24]([C:25]#[N:26])=[CH:23][C:22]=1[CH2:29][CH3:30].Cl.N([O-])=O.[Na+].[CH2:36]=[N:37][OH:38]>O.[Cl-].[Na+].O.S([O-])([O-])(=O)=O.[Cu+2]>[C:25]([C:24]1[CH:27]=[CH:28][C:21]([CH:36]=[N:37][OH:38])=[C:22]([CH2:29][CH3:30])[CH:23]=1)#[N:26]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

12

반응물 8

HCID 313Hydrochloric AcidHCID 712FormaldehydeHCID 6350NitroneHCID 24437Sodium SulfiteHCID 443297Hydroxyamine hydrochlorideHCID 27353304-Amino-3-ethylbenzonitrile2회HCID 23665404Sodium Acetate Trihydrate3회
HCID 23668193
Sodium Nitrite

생성물 1

HCID 734109644-Cyano-2-ethylbenzaldehyde oxime

시약·촉매·용매 3

HCID 24462Copper Sulfate촉매HCID 962Water용매5회HCID 57417360Sodium chloride; water용매

실험 절차

4-Cyano-2-ethylbenzaldehyde oxime was prepared by the procedure of Jolad et al., Org. Syntheses, Coll. Vol. V, 139 (1973). A mixture of paraformaldehyde (2.8 g, 93 mmol) and hydroxylamine hydrochloride (6 g, 86 mmol) in water (39 mL) was heated in a 500 mL 3-necked flask. When a clear, colorless solution was obtained, sodium acetate trihydrate (11.8 g, 87 mmol) was added. The solution was heated for 15 minutes, then cooled in an ice-salt bath to approximately 5°-10° C. To this solution was added copper sulfate (0.97 g, 6.08 mmol), sodium sulfite (0.23 g, 1.82 mmol) and sodium acetate trihydrate (37 g, 272 mmol) in water (42 mL). The resulting green solution was cooled to an internal temperature of approximately 5°-10° C. A diazonium salt solution of 4-amino-3-ethylbenzonitrile was previously prepared as follows: A mixture of 4-amino-3-ethylbenzonitrile (8.32 g, 57 mmol), concentrated hydrochloric acid (13.2 mL), ice (23 g), and water (11.6 mL) was cooled in an ice-salt bath. While maintaining the internal temperature below 10° C., a solution of sodium nitrite (4.2 g, 61 mmol) in water (5.8 mL) was added dropwise. The resulting slurry was stirred at 5°-10° C. for an additional 15 minutes. Then a solution of sodium acetate trihydrate (5.1 g, 37 mmol) in water (8.1 mL) was added. This solution of the diazonium salt was siphoned under the surface of the 10% formaldoxime solution. The reaction mixture was stirred vigorously and allowed to slowly warm to room temperature as the ice-salt bath melted. After 2 hours the reaction mixture was diluted with brine (100 mL), extracted with dichloromethane (2×400 mL), and dried (Na2 SO4). Purification by chromatography (silica gel, hexane:ethyl acetate (7:1)) gave 2.97 g (30%) of a solid: 1H NMR (DMSO-d6) δ11.80 (s, 1H), 8.45 (s, 1H), 8.00-7.60 (m, 3H), 2.90 (m, 2H), 1.20 (m, 3H).

후처리

  1. temperaturewas heated in a 500 mL 3-necked flask
  2. customWhen a clear, colorless solution was obtained
  3. temperatureThe solution was heated for 15 minutes
  4. temperaturecooled in an ice-salt bath to approximately 5°-10° C
  5. temperatureThe resulting green solution was cooled to an internal temperature of approximately 5°-10° C
  6. temperaturewas cooled in an ice-salt bath
  7. temperatureWhile maintaining the internal temperature below 10° C.
  8. stirringThe reaction mixture was stirred vigorously
  9. extractionextracted with dichloromethane (2×400 mL)
  10. customdried (Na2 SO4)
  11. customPurification by chromatography (silica gel, hexane:ethyl acetate (7:1))

출처 및 근거

ORD 기록
ord-a4045eb778634cbbae4daa378fad2e32
출처 데이터셋
uspto-grants-1998_07
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05780505

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트