홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Acetic Anhydride → Butanoic acid, 2-(ethoxymethylene)-4,4-difluoro-3-oxo-, ethyl ester

HRID 222777
인쇄

반응식

HRID 222777 반응식
[C:1]([O:4][C:5](=O)C)(=O)[CH3:2].[F:8][CH:9]([F:18])[C:10](=[O:17])[CH2:11][C:12]([O:14][CH2:15][CH3:16])=[O:13].C(OCC)(OCC)OCC.FC(F)C(OCC)=O>C(O)C.C(OCC)(=O)C>[CH2:1]([O:4][CH:5]=[C:11]([C:10](=[O:17])[CH:9]([F:18])[F:8])[C:12]([O:14][CH2:15][CH3:16])=[O:13])[CH3:2]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 4

HCID 7918Acetic AnhydrideHCID 9961Ethyl difluoroacetateHCID 31214Ethyl orthoformateHCID 67697Butanoic acid, 4,4-difluoro-3-oxo-, ethyl ester2회

생성물 1

HCID 53395411Butanoic acid, 2-(ethoxymethylene)-4,4-difluoro-3-oxo-, ethyl ester

시약·촉매·용매 1

HCID 21584252
Ethanol ethylacetate
용매

반응 조건

온도
110 °C

실험 절차

365.2 g of acetic anhydride (3.54 mol) were initially charged in the stirred vessel and heated to 110° C. Within 2 hours, 356.3 g of crude ethyl 4,4-difluoroacetoacetate from synthesis example 7 (26.5% ethyl 4,4-difluoroacetoacetate solution in ethanol/ethyl acetate) and 154.4 g (1.02 mol) of triethyl orthoformate were metered in in parallel. After about half had been fed in, reflux set in at 106° C. At the end of the metered addition, the internal temperature was 92° C. The mixture was stirred for a further 5 hours at reflux temperature and then cooled to 25° C. At a pressure of 150 mbar, the low boilers (ethyl acetate, acetic acid, acetic anhydride, triethyl orthoformate) were distilled off at internal temperature from 40-90° C. To complete the removal, the pressure is lowered to 5 mbar at 90° C., and the distillation bottoms are then stirred at 95° C./5 mbar for 1 hour. The resulting distillation residue (127.5 g) comprised 90.7% by weight of the desired ethyl 2-ethoxymethylene-4,4-difluoro-3-oxobutyrate. This corresponds to an overall yield over the two synthesis stages of 86.6% (based on the ethyl difluoroacetate used in working example 7).

후처리

  1. temperaturereflux
  2. customset in at 106° C
  3. additionAt the end of the metered addition
  4. customwas 92° C
  5. temperatureat reflux temperature
  6. temperaturecooled to 25° C
  7. distillationAt a pressure of 150 mbar, the low boilers (ethyl acetate, acetic acid, acetic anhydride, triethyl orthoformate) were distilled off at internal temperature from 40-90° C
  8. customthe removal
  9. customis lowered to 5 mbar at 90° C.
  10. distillationthe distillation
  11. stirringbottoms are then stirred at 95° C./5 mbar for 1 hour
  12. distillationThe resulting distillation residue (127.5 g)
  13. customThis corresponds to an overall yield over the two synthesis stages of 86.6% (

출처 및 근거

ORD 기록
ord-b9e116ce6e9b4a73bd84d751e246c866
출처 데이터셋
uspto-grants-2012_06
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US08207354B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트