홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Dimethyl Sulfoxide → 4-(2-Methylimidazole-1-yl)-2,2-diphenylbutyronitrile phosphate

HRID 252622
인쇄

반응식

HRID 252622 반응식
Br[CH2:2][CH2:3][C:4]([C:13]1[CH:18]=[CH:17][CH:16]=[CH:15][CH:14]=1)([C:7]1[CH:12]=[CH:11][CH:10]=[CH:9][CH:8]=1)[C:5]#[N:6].[CH3:19][C:20]1[NH:21][CH:22]=[CH:23][N:24]=1.CS(C)=O.[P:29](=[O:33])([OH:32])([OH:31])[OH:30]>C(O)C.O.C(OCC)(=O)C>[P:29]([OH:33])([OH:32])([OH:31])=[O:30].[CH3:19][C:20]1[N:21]([CH2:2][CH2:3][C:4]([C:13]2[CH:18]=[CH:17][CH:16]=[CH:15][CH:14]=2)([C:7]2[CH:12]=[CH:11][CH:10]=[CH:9][CH:8]=2)[C:5]#[N:6])[CH:22]=[CH:23][N:24]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

8

반응물 4

HCID 679Dimethyl SulfoxideHCID 1004Phosphoric AcidHCID 127492-MethylimidazoleHCID 965754-Bromo-2,2-diphenylbutyronitrile

생성물 1

HCID 100009654-(2-Methylimidazole-1-yl)-2,2-diphenylbutyronitrile phosphate수율 74.5%

시약·촉매·용매 3

HCID 702
Ethanol
용매
2회
HCID 962Water용매
HCID 8857Ethyl Acetate용매

반응 조건

온도
100 °C

실험 절차

A mixture of 500 g (1.67 mol) of 4-bromo-2,2-diphenylbutyronitrile, 685 g (8.34 mol) of 2-methylimidazole and 250 mL of dimethylsulfoxide (DMSO) was stirred for 5 hours at 95 to 105° C., and then cooled with ice water. After 2 L of ethyl acetate and 2 L of water were added therein at an inner temperature of 39° C., and the mixture was stirred for 5 minutes, organic layer was separated. After washing the organic layer with 2 L of water and then 2 L of 2.5% acetic acid, the organic layer was concentrated under reduced pressure. The residual oil was dissolved in 2 L of ethanol and to this solution a solution of 192 g (1.67 mol) of 85% phosphoric acid and 1 L of ethanol was added dropwise at an inner temperature of 31° C. under stirring, and this dropwise addition was interrupted when the solution became milky white (about 500 mL were added dropwise). After confirming the precipitation of crystals by stirring for 30 minutes, remaining phosphoric acid solution was added dropwise, and successively the solution was stirred for 16 hours at an inner temperature of 30° C. The precipitated crystals were collected by filtration and, after washing them with 1 L of ethanol, the crystals were dried for 5 hours at 60° C. under reduced pressure (vacuum pump) to obtain 496 g (74.5%) of 4-(2-methylimidazole-1-yl)-2,2-diphenylbutyronitrile phosphate. Out of these crystals, 100 g were completely dissolved with stirring into a mixture of 100 mL of purified water and 400 mL of 2-propanol and to this solution 500 mL of 2-propanol were added under stirring, followed by cooling with ice water. After stirring this solution for 1 hour at an inner temperature of below 15° C., the precipitated crystals were collected by filtration which were then washed with 100 mL of 2-propanol, then with 100 mL of ethyl acetate. The crystals were dried for 17 hours at 60° C. under reduced pressure (vacuum pump) to obtain 91.3 g (Total yield: 68%) of purified product of 4-(2-methylimidazole-1-yl)-2,2-diphenylbutyronitrile phosphate as white crystalline powder with hygroscopicity. After a mixture of 80.0 g (200 mmol) of the purified product thus obtained, 132 g (2.02 mol) of 86% potassium hydroxide and 400 ml of 2-propanol was refluxed for 5 hours under an atmosphere of argon, the mixture was cooled with ice water. Under stirring, 800 mL of 2 mol/L hydrochloric acid were added into the mixture at an inner temperature of 30° C. (temperature was raised to 50° C.) to crystallize out of the mixture, and, after stirring for 1 hour at an inner temperature of below 15° C., the crystals were collected from the solution by filtration. These crystals were washed with a mixture of 30 mL of 2-propanol and 60 mL of purified water, then with each 250 mL of purified water five times (fifth washed solution: pH 8.80). The crystals were dried for 16 hours at 40° C. in blower to obtain 55.2 g (86.4%) of crude crystals. Into a mixed solution of 200 mL of 95% 2-propanol, 27.6 g out of these were dissolved completely by heating, which was then stirred for 1 hour at room temperature to crystallize out of the solution, followed by cooling with ice water. After stirring the solution for 1 hour at an inner temperature of below 15° C., the precipitated crystals were collected by filtration and washed with 10 mL of 2-propanol. The crystals were dried for 3 hours at 60° C. under reduced pressure (vacuum pump) to obtain 25.7 g (Total yield: 80%) of crude crystals of 4-(2-methylimidazole-1-yl)-2,2-diphenylbutanamide as white crystalline powder.

후처리

  1. stirringat an inner temperature of 39° C., and the mixture was stirred for 5 minutes
  2. customorganic layer was separated
  3. washAfter washing the organic layer with 2 L of water
  4. concentration2 L of 2.5% acetic acid, the organic layer was concentrated under reduced pressure
  5. additionwas added dropwise at an inner temperature of 31° C.
  6. stirringunder stirring
  7. additionthis dropwise addition
  8. additionwere added dropwise)
  9. customthe precipitation of crystals
  10. stirringby stirring for 30 minutes
  11. additionwas added dropwise
  12. stirringsuccessively the solution was stirred for 16 hours at an inner temperature of 30° C
  13. filtrationThe precipitated crystals were collected by filtration
  14. washafter washing them with 1 L of ethanol
  15. customthe crystals were dried for 5 hours at 60° C. under reduced pressure (vacuum pump)

출처 및 근거

ORD 기록
ord-24c1f35b4d2a4496b8cc977788a0a8d5
출처 데이터셋
uspto-grants-2011_01
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07868183B2

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트