홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.1
  1. 홈
  2. /반응

1,5-Naphthalenedisulfonic acid → Phosphate

HRID 269706
인쇄

반응식

HRID 269706 반응식
C1(S(O)(=O)=O)C2C=CC=C(S(O)(=O)=O)C=2C=CC=1.[Na][Na].[Na].[P:22]([O-:26])([O-:25])([O-:24])=[O:23].[OH-].[Na+].[O-:29][P:30]([O:33][P:34]([O:37][P:38]([O-:41])([O-:40])=[O:39])([O-:36])=[O:35])([O-:32])=[O:31].[Na+].[Na+].[Na+].[Na+].[Na+].C1(S(O)(=O)=O)C(S(O)(=O)=O)=CC=C2C=1C=CC=C2.[Na].[Na]>O>[O-:41][P:38]([O:37][P:34]([O:33][P:30]([O-:32])([O-:31])=[O:29])([O-:36])=[O:35])([O-:40])=[O:39].[P:22]([O-:26])([O-:25])([O-:24])=[O:23]
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

9

반응물 6

HCID 66661,5-Naphthalenedisulfonic acid3회HCID 14798Sodium HydroxideHCID 24455Sodium Tripolyphosphate2회HCID 141233Disodium2회HCID 87774290Disodium naphthalene disulfonic acid2회HCID 131727175CID 131727175

생성물 2

HCID 1061Phosphate
HCID 3440921Triphosphate

시약·촉매·용매 1

HCID 962Water용매

실험 절차

Here is an example of the use of 1,5 naphthalenedisulfonic acid, disodium salt at a coal-fired power plant. The 1,5 naphthalenedisulfonic acid was applied to the high-pressure steam generator operating at 2000 psig (636° F.). The 1,5 naphthalenedisulfonic acid, disodium salt was added in combination with sodium/phosphate-based program. The treatment was supplied to the boiler by diluting a liquid product in a daytank and pumping the resulting dilute solution into the chemical injection line in the steam drum of the boiler. Sodium hydroxide was added to the tank as needed to control boiler pH. The liquid product contained sodium tripolyphosphate and disodium naphthalene disulfonic acid dissolved in deionized water. The mass ratio of sodium tripolyphosphate to disodium naphthalene disulfonic acid in the liquid product was 28:1. The tripolyphosphate ion hydrolyses immediately in the high temperature boiler conditions to produce orthophosphate ion PO4. The orthophosphate ion was analyzed by various wet chemistry and spectroscopic techniques in the boiler water. The fluorometers measuring the naphthalene disulfonic acid fluorescence were calibrated to read directly in ppm orthophosphate based on the ratio of sodium tripolyphosphate to disodium naphthalene disulfonic acid in the liquid product. This fluorometer calibration allowed for a direct comparison of the data from the orthophosphate tests and the fluorometric readings. If the orthophosphate test data differed from the fluorometric readings that would be evidence of a chemical reaction that had changed the ratio of phosphate to fluorophore in the boiler water as compared to the ratio found in the original liquid product injected into the boiler. FIG. 2 shows the 1,5 naphthalenedisulfonic acid, disodium salt and PO4 readings, both in terms of ppm PO4 over eighty day time period.

후처리

  1. customwas applied to the high-pressure steam generator operating at 2000 psig (636° F.)
  2. additionby diluting a liquid product in a daytank

출처 및 근거

ORD 기록
ord-04bbc27c5ca84264a7efe1e4081bf493
출처 데이터셋
uspto-grants-2008_11
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US07448255B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트