홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

3-Methoxypyridine → 3-Methylpyridine

HRID 359909
인쇄

반응식

HRID 359909 반응식
[NH2-:1].[Na+].[C:3](O)(=O)CCCCCCC/C=C\CCCCCCCC.CO[C:25]1[CH:26]=[N:27][CH:28]=[CH:29][CH:30]=1>C1(C)C=CC=CC=1>[CH3:3][C:25]1[CH:26]=[N:27][CH:28]=[CH:29][CH:30]=1.[NH2:1][C:28]1[CH:29]=[CH:30][CH:25]=[CH:26][N:27]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 3

HCID 237193-MethoxypyridineHCID 24533Sodium amideHCID 445639Oleic Acid

생성물 2

HCID 79703-MethylpyridineHCID 104392-Aminopyridine

시약·촉매·용매 1

HCID 1140Toluene용매

반응 조건

온도
120 °C

실험 절차

A mixture of 28.1 g (0.72 mole) of sodamide, 400 cc of toluene containing 0.1 cc of oleic acid, and 65.5 g (0.60 mole) of 3-methoxypyridine was placed in a liter Magne Drive, equipped as described in Example 15. The autoclave was closed and purged of air with ammonia, pressurized to 30 psig with ammonia and then to 200 psig with nitrogen. The pressure relief valve was set at 340 psig. Cooling water was turned on the reflux condenser. The mixture was heated with stirring to 120° C. and kept heating (maximum temperature 136° C.) for about 4.5 hours until noncondensable gases stopped passing through the pressure relief valve. The autoclave was cooled the 25° C., vented to atmospheric pressure, and hydrolyzed with 150 cc of water. The oil phase was separated. The aqueous phase was extracted twice with 50 cc of an equal volume solution of 4-picoline and toluene. The oil layer and extracts were combined and distilled under vacuum to give 0.14 mole of recovered 3-methypyridine, 0.05 moles of 2-aminopyridine. 0.02 moles of 3-aminopyridine, 0.02 moles of 2-amino-3-methylpyridine, and 0.18 moles of 3-hydroxypyridine. When 3-methoxypyridine was aminated with sodamide in refluxing xylene at atmospheric pressure, a 40.3% yield of 2-amino-3-methoxypyridine (m.p. 79°-80° C.) was obtained. Both 2-amino-3-methylpyridine and 2-amino-3-methoxypyridine are valuable as starting materials for preparing herbicides as shown in Suzuki et al., Ger. Offen. 2,831,578 (1979). The 3-hydroxypyridine is a valuable starting material for the preparation of the drugs pirbuterol (cardiostimulant and oral brochodialator) and pyridostigmine (cholinergic).

후처리

  1. customequipped
  2. customThe autoclave was closed
  3. custompurged of air with ammonia
  4. temperatureThe mixture was heated
  5. temperaturekept heating (maximum temperature 136° C.) for about 4.5 hours until noncondensable gases
  6. temperatureThe autoclave was cooled the 25° C.
  7. customThe oil phase was separated
  8. extractionThe aqueous phase was extracted twice with 50 cc of an equal volume solution of 4-picoline and toluene
  9. distillationdistilled under vacuum

출처 및 근거

ORD 기록
ord-a4688ce8e267411aaa2dac98eaa02283
출처 데이터셋
uspto-grants-1991_03
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05003069

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트