홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Methanol → Quinacridone

HRID 861202
인쇄

반응식

HRID 861202 반응식
[NH:1]([C:8]1[CH:16]=[C:15]([C:17](O)=[O:18])[C:14]([NH:20][C:21]2[CH:26]=[CH:25][CH:24]=[CH:23][CH:22]=2)=[CH:13][C:9]=1[C:10](O)=[O:11])[C:2]1[CH:7]=[CH:6][CH:5]=[CH:4][CH:3]=1.P(=O)(O)(O)O.CO>O.C1C=C2C3N=C(C2=CC=1)N=C1C2C(C(=N1)N=C1C4C(C(=N1)N=C1C5C(C(=N1)N=3)=CC=CC=5)=CC=CC=4)=CC=CC=2.[Cu]>[CH:24]1[CH:25]=[C:26]2[C:17]([C:15]3[C:14]([NH:20][C:21]2=[CH:22][CH:23]=1)=[CH:13][C:9]1[C:10]([C:7]2[C:2]([NH:1][C:8]=1[CH:16]=3)=[CH:3][CH:4]=[CH:5][CH:6]=2)=[O:11])=[O:18]
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

6

반응물 3

HCID 887MethanolHCID 1004Phosphoric AcidHCID 823512,5-Dianilinoterephthalic acid

생성물 1

HCID 13976Quinacridone수율 88.3%

시약·촉매·용매 2

HCID 475701Monastral Blue B촉매HCID 962Water용매

반응 조건

온도
95 °C

실험 절차

To 300 g of polyphosphoric acid (117% phosphoric acid) heated at 90° C. was added 0.7 g of copper phthalocyanine followed by 68.2 g of 2,5-dianilinoterephthalic acid. The mixture was heated at 120°-125° C. for two hours. After the melt was cooled to 95° C., the acid strength was adjusted to 112% by the dropwise addition of phosphoric acid. The resultant melt was stirred for 15 minutes and then slowly poured into 453 g of methanol at 24° C. During the drown, the temperature was allowed to increase to 55° C., with the temperature being controlled by external cooling and adjustment of melt addition rate. The slurry was heated at reflux (68°-72° C.) for one hour, diluted with water, and stirred at 60° C. for 30 minutes. The solid component was collected by filtration and washed with water until acid free. The resultant presscake was reslurried in water. After adjustment of the pH to greater than 7, 7.5 g of 50% sodium hydroxide was added and the resultant slurry was heated at 90° C. for one hour. The slurry was cooled, filtered, and washed with water until alkali free, then reslurried in water. After adjustment of the pH to greater than 8.5, 3.2 g of a cycloaliphatic carboxylic acid was added. The resultant slurry was heated at about 140°-145° C. for two hours in a closed system, cooled, acidified with phosphoric acid, and stirred. The solid component was collected by filtration and washed with water. The wet cake can be dried or used as is for specific applications. Here, the wet cake was dried in an oven at 60° C. to give approximately 54.0 g of quinacridone as a brilliant violet pigment.

후처리

  1. temperatureThe mixture was heated at 120°-125° C. for two hours
  2. temperatureto increase to 55° C., with the temperature
  3. temperatureby external cooling
  4. additionadjustment of melt addition rate
  5. temperatureThe slurry was heated
  6. temperatureat reflux (68°-72° C.) for one hour
  7. stirringstirred at 60° C. for 30 minutes
  8. filtrationThe solid component was collected by filtration
  9. washwashed with water until acid free
  10. additionAfter adjustment of the pH to greater than 7, 7.5 g of 50% sodium hydroxide was added
  11. temperaturethe resultant slurry was heated at 90° C. for one hour
  12. temperatureThe slurry was cooled
  13. filtrationfiltered
  14. washwashed with water until alkali free,
  15. additionAfter adjustment of the pH to greater than 8.5, 3.2 g of a cycloaliphatic carboxylic acid was added
  16. temperatureThe resultant slurry was heated at about 140°-145° C. for two hours in a closed system
  17. temperaturecooled
  18. stirringstirred
  19. filtrationThe solid component was collected by filtration
  20. washwashed with water
  21. customThe wet cake can be dried
  22. customHere, the wet cake was dried in an oven at 60° C.

출처 및 근거

ORD 기록
ord-61ceddd594654c65b298b05a97fce4c1
출처 데이터셋
uspto-grants-1998_02
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US05713999

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트