反应详情

Lithium wire (2.1 g, 303 mmol) in small pieces in 26 ml of dry tetrahydrofuran containing a trace of naphthalene under argon was cooled to -15° and was treated with 3.32 g (24.8 mmol) of allyl phenyl ether in 14 ml of tetrahydrofuran containing a trace of naphthalene, with rapid stirring for 45 minutes. After an additional 1.25 hours at room temperature, 14.7 ml (ca. 6.6 mmol) of the allyllithium solution was added at -15° over 2 minutes to 635 mg (3.3 mmol) of copper iodide in 10 ml of tetrahydrofuran under argon with rapid stirring. After 5 minutes, the dark solution was of lithium diallylcuprate cooled to -78° and 245 mg (3.0 mmol) of cyclopentenone in 2 ml of tetrahydrofuran was added over 2 minutes. After 40 minutes at -78°, 1 ml of tetramethylethylenediamine was added followed 5 minutes later by 3.0 g (15.5 mmol) of 1-iodo-2-pentyne in 10 ml of hexamethylphosphoramide. After 2 additional hours at -78°, 1 ml of methanol was added and the mixture was poured into aqueous ammonium chloride-ammonium hydroxide-ether. After rapidly stirring for 15 minutes, the organic phase was separated and washed successively with aqueous sodium hydroxide, aqueous hydrochloric acid, aqueous sodium thiosulfate, and aqueous sodium chloride. After drying over potassium carbonate, the solvent was removed under reduced pressure and the resulting oil was chromatographed on silica gel using chloroform-hexane to afford 325 mg of 2-pentynyl, 3-allylcyclopentanone (57%).

1. waitAfter an additional 1.25 hours at room temperature
2. waitAfter 5 minutes
3. temperaturecooled to -78°
4. waitAfter 40 minutes at -78°
5. stirringAfter rapidly stirring for 15 minutes
6. customthe organic phase was separated
7. washwashed successively with aqueous sodium hydroxide, aqueous hydrochloric acid, aqueous sodium thiosulfate, and aqueous sodium chloride
8. dry with materialAfter drying over potassium carbonate
9. customthe solvent was removed under reduced pressure
10. customthe resulting oil was chromatographed on silica gel