StartseiteMCPWorkbenchSkills
StartseiteWorkbenchBenachrichtigungenMein Bereich
llms.txt · MCP-AnleitungDatenschutz · Nutzungsbedingungen · Supportv1.8.0
  1. Startseite
  2. /Reaktion

Oxygen → HCID 86639767, Verbindung

HRID 659896
Notizen
Druckvorschau

Reaktionsgleichung

Reaktionsgleichung von HRID 659896
[CH2:1]([Li])[CH2:2][CH2:3][CH3:4].O=O.Br[C:9]1[CH:14]=[CH:13][C:12]([F:15])=[C:11]([CH2:16][C:17]2[CH:22]=[CH:21][C:20]([O:23][CH3:24])=[CH:19][CH:18]=2)[CH:10]=1.CON(C)[C:28](=[O:80])[C@H:29]([O:72]CC1C=CC=CC=1)[C@@H:30]([O:64][CH2:65][C:66]1[CH:71]=[CH:70][CH:69]=[CH:68][CH:67]=1)[C@H:31]([O:56][CH2:57][C:58]1[CH:63]=[CH:62][CH:61]=[CH:60][CH:59]=1)[C:32]([OH:55])([CH2:44][O:45][CH2:46][C:47]1[CH:52]=[CH:51][C:50]([O:53][CH3:54])=[CH:49][CH:48]=1)[CH2:33][O:34][CH2:35][C:36]1[CH:41]=[CH:40][C:39]([O:42][CH3:43])=[CH:38][CH:37]=1.[Al].O1C[CH2:86][CH2:85][CH2:84]1>C(OCC)C>[CH2:1]([O:72][CH:29]1[C@@H:30]([O:64][CH2:65][C:66]2[CH:67]=[CH:68][CH:69]=[CH:70][CH:71]=2)[C@H:31]([O:56][CH2:57][C:58]2[CH:63]=[CH:62][CH:61]=[CH:60][CH:59]=2)[C:32]([CH2:44][O:45][CH2:46][C:47]2[CH:48]=[CH:49][C:50]([O:53][CH3:54])=[CH:51][CH:52]=2)([CH2:33][O:34][CH2:35][C:36]2[CH:37]=[CH:38][C:39]([O:42][CH3:43])=[CH:40][CH:41]=2)[O:55][C:28]1([C:9]1[CH:14]=[CH:13][C:12]([F:15])=[C:11]([CH2:16][C:17]2[CH:22]=[CH:21][C:20]([O:23][CH3:24])=[CH:19][CH:18]=2)[CH:10]=1)[OH:80])[C:2]1[CH:86]=[CH:85][CH:84]=[CH:4][CH:3]=1
KomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion

Komponenten

8

Edukt 6

HCID 977OxygenHCID 8028Tetrahydrofuran2×HCID 5359268AluminumHCID 581784764-Bromo-1-fluoro-2-(4-methoxy-benzyl)-benzeneHCID 59226798(2R,3S,4S)-2,3,4-tris-benzyloxy-5-hydroxy-6-(4-methoxy-benzyloxy)-5-(4-methoxy-benzyloxymethyl)-hexanoic acid methoxy-methyl-amideHCID 178418339Butyllithium

Produkt 1

HCID 86639767HCID 86639767, VerbindungAusbeute 55 %

Reagenzien, Katalysatoren, Lösungsmittel 1

HCID 3283Diethyl EtherLösungsmittel

Reaktionsbedingungen

Temperatur
10 °C

Versuchsvorschrift

n-Butyl lithium (462 microL, 2.5 M/hexanes, 3.0 equivalents) was added dropwise (1 drop every 5 seconds) to an oxygen degassed solution (placed in a pre dried Biotage™ microwave vial 10-20 mL sealed with its cap and placed under a positive stream of nitrogen gas) of 4-Bromo-1-fluoro-2-(4-methoxy-benzyl)-benzene (341 mg, 3 equivalents) in anhydrous tetrahydrofuran (1.4 mL) at −78° C. under nitrogen. The resulting solution was stirred at this temperature for 1 hour. Then a solution of (2R,3S,4S)-2,3,4-tris-benzyloxy-5-hydroxy-6-(4-methoxy-benzyloxy)-5-(4-methoxy-benzyloxymethyl)-hexanoic acid methoxy-methyl-amide (I-1g) (300 mg, 0.385 mmol) in anhydrous tetrahydrofuran (0.70 mL) was added dropwise very slowly (1 drop every 5 seconds) and the resulting mixture was stirred at −78° C. for an additional hour before warming to 10° C. over 12 hours (put in a deep Dewar covered with aluminum foil to maintain cold temperature; size of Dewar: external diameter 10 cm, internal diameter 8 cm, height 9 cm). The reaction was diluted with diethyl ether and quenched by the dropwise addition of aqueous 1N hydrochloric acid solution. The resulting biphasic mixture was stirred at room temperature for 15 minutes. The organic phase was separated, washed with brine, dried over magnesium sulfate, filtered, and concentrated under reduced pressure. The crude residue was purified by flash chromatography over silica gel (eluting with a gradient of 10 to 40% ethyl acetate in heptane) to afford the product as a mixture of isomers (199 mg, 55% yield).

Aufarbeitung

  1. customdried Biotage™ microwave vial 10-20 mL
  2. customsealed with its
  3. customcap
  4. customat −78° C.
  5. stirringthe resulting mixture was stirred at −78° C. for an additional hour
  6. temperatureto maintain cold temperature
  7. customquenched by the dropwise addition of aqueous 1N hydrochloric acid solution
  8. stirringThe resulting biphasic mixture was stirred at room temperature for 15 minutes
  9. customThe organic phase was separated
  10. washwashed with brine
  11. dry with materialdried over magnesium sulfate
  12. filtrationfiltered
  13. concentrationconcentrated under reduced pressure
  14. customThe crude residue was purified by flash chromatography over silica gel (
  15. washeluting with a gradient of 10 to 40% ethyl acetate in heptane)
  16. customto afford the product
  17. additionas a mixture of isomers (199 mg, 55% yield)

Quellen und Nachweise

ORD-Eintrag
ord-6ad9e7a35b864ae994a92cc60b1e9548
Quelldatensatz
uspto-grants-2011_12
DOI
10.6084/m9.figshare.5104873.v1
Patentnummer
US08080580B2

Notizen zur Reaktion

Wird geladen…

Auf dieser SeiteKomponentenReaktionsbedingungenVersuchsvorschriftAufarbeitungQuellen und NachweiseNotizen zur Reaktion