홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Hydrochloric Acid → 4-(2,3-dihydro-1H-indol-6-ylamino)-6-methoxy-7-(3-pyridin-4-yl-propoxy)-quinoline-3-carbonitrile

HRID 1595771
인쇄

반응식

HRID 1595771 반응식
C1(P(C2C=CC=CC=2)C2C=CC=CC=2)C=CC=CC=1.[OH:20][CH2:21][CH2:22][CH2:23][C:24]1[CH:29]=[CH:28][N:27]=[CH:26][CH:25]=1.[NH:30]1[C:38]2[C:33](=[CH:34][CH:35]=[C:36]([NH:39][C:40]3[C:49]4[C:44](=[CH:45][C:46](O)=[C:47]([O:50][CH3:51])[CH:48]=4)[N:43]=[CH:42][C:41]=3[C:53]#[N:54])[CH:37]=2)[CH2:32][CH2:31]1.CCOC(/N=N/C(OCC)=O)=O.Cl.C(=O)(O)[O-].[Na+]>O.O1CCCC1.C(Cl)(Cl)Cl>[NH:30]1[C:38]2[C:33](=[CH:34][CH:35]=[C:36]([NH:39][C:40]3[C:49]4[C:44](=[CH:45][C:46]([O:20][CH2:21][CH2:22][CH2:23][C:24]5[CH:29]=[CH:28][N:27]=[CH:26][CH:25]=5)=[C:47]([O:50][CH3:51])[CH:48]=4)[N:43]=[CH:42][C:41]=3[C:53]#[N:54])[CH:37]=2)[CH2:32][CH2:31]1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

10

반응물 6

HCID 313Hydrochloric AcidHCID 11776Triphenylphosphine2회HCID 729234-Pyridinepropanol2회HCID 516892Sodium BicarbonateHCID 5462977Diethyl azodicarboxylate2회HCID 1360184074-(2,3-dihydro-1H-indol-6-ylamino)-7-hydroxy-6-methoxy-quinoline-3-carbonitrile

생성물 1

HCID 101824544-(2,3-dihydro-1H-indol-6-ylamino)-6-methoxy-7-(3-pyridin-4-yl-propoxy)-quinoline-3-carbonitrile

시약·촉매·용매 3

HCID 962Water용매HCID 6212Chloroform용매2회HCID 8028Tetrahydrofuran용매3회

실험 절차

To a 0° C. solution consisting of 2 ml of chloroform, 1 ml of tetrahydrofurane, 167 mg (0.64 mM) of triphenyl phosphine, 52 μl (0.40 mM) of 4-hydroxypropylpyridine and 107 mg (0.32 mM) of the 4-(2,3-dihydro-1H-indol-6-ylamino)-7-hydroxy-6-methoxy-quinoline-3-carbonitrile, was slowly added 101 μL (0.64 mM) of DEAD. The reaction was allowed to run at 0° C. for 15 min and then allowed to warm to room temperature. The heterogeneous solution was allowed to stir at room temperature for 7 hour. TCL and ES MS showed no signs of product formation. An additional 1 ml of chloroform and 500 mL of tetrahydrofurane was added and the reaction was refluxed for 14 hours. Once again no signs of product formation were seen. The volume of the reaction was reduced to 1 ml by heating and then brought up to 4 ml by addition of tetrahydrofurane. Once the reaction had cooled to room temperature, and additional 80 mg (0.32 mM) of triphenyl phosphine, 25 μl (0.20 mM) of 4-hydroxypropylpyridine was added followed by the slow addition of 50 μL (0.32 mM) of DEAD. The reaction quickly turned to a clear brown solution. After six hours at room temperature, TLC and the mass spectrum showed the reaction was complete. To the reaction mixture was added 10 ml of 1N HCl followed by 20 ml of water. The solution was extracted five time with 25 ml portions of chloroform. The water layer was allowed to stand for three hours at room temperature and the resulting brown solid was isolated by filtration. The filtrate was treated with solid sodium bicarbonate until a yellow solid fell from solution. The precipitate was isolated and washed with excess water followed by 1 ml of diethyl ether and dried under vacuum at 80° C. to give 57 mg of 4-(2,3-dihydro-1H-indol-6-ylamino)-6-methoxy-7-(3-pyridin-4-yl-propoxy)-quinoline-3-carbonitrile as a yellow solid: mass spectrum (electrospray, m/e): 452.3 M+H, 226.7 M+2H/2, mp=100-105° C.

후처리

  1. customTo a 0° C.
  2. temperaturethe reaction was refluxed for 14 hours
  3. temperatureby heating
  4. temperatureOnce the reaction had cooled to room temperature
  5. customThe reaction
  6. waitAfter six hours at room temperature
  7. extractionThe solution was extracted five time with 25 ml portions of chloroform
  8. waitto stand for three hours at room temperature
  9. customthe resulting brown solid was isolated by filtration
  10. customThe precipitate was isolated
  11. washwashed with excess water
  12. customdried under vacuum at 80° C.

출처 및 근거

ORD 기록
ord-ff0438eb7ded4b5bb56939fa2f941fdd
출처 데이터셋
uspto-grants-2001_09
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06288082B1

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트