Formic Acid → HCID 16039065, compound

Temperature

10 °C

Into a three-necked flask having an inner volume of 3 L equipped with a stirrer, a thermometer and a dropping funnel, the whole amount of “Aqueous Solution A” obtained above was poured, and cooled down to 10° C. 99% Formic acid (93.27 g, 2.01 mol) was weighed into a dropping funnel, and added dropwise to the reaction system so that the inner temperature of the reaction system was maintained in a range of 11 to 15° C. After that, the inner temperature was raised up to 50 to 53° C. by heating, and then 30% hydrogen peroxide aqueous solution (162.50 g, 1.43 mol) weighed and contained in another dropping funnel was added dropwise to the reaction system over 3 hours. It should be noted that, after completion of the dropping, the inner temperature of the reaction system was also maintained at around 50° C. After 17 hours from completion of the dropping, the reaction liquid was analyzed by HPLC to confirm that conversion ratio of sodium 5-bornene-2-sulfonate was 98.7%. After cooling down the reaction liquid to 15° C., sodium sulfite was added slowly to the reaction system so that the inner temperature of the reaction system maintained in a range of 15 to 19° C. until a starch paper did not detect hydrogen peroxide. Subsequently, sodium hydrogen carbonate was added slowly to adjust pH of the reaction liquid at 7.3 so that the inner temperature of the reaction system was maintained in a range of 15 to 17° C. The reaction liquid was extracted with ethyl acetate (900 g) twice, and the obtained organic layers were combined, washed with water (200 g), and then concentrated under the reduced pressure until the amount of the liquid became 138.3 g. Isopropyl ether (103.7 g) was added to the resultant concentrated liquid in a heated state at 50° C., then the reaction liquid was cooled down to 5° C. at a rate of about 10° C./hour, to precipitate crystal of the product. After filtering the precipitated crystal, the filtered out crystal was washed with isopropyl ether (50 g) at 5° C., and dried at 40° C. for 2 hours under the reduced pressure, to obtain 2-hydroxy-4-oxa-5-thiatricyclo[4.2.1.03,7]nonane 5,5-dioxide (53.9 g, purity: 99.1%, 0.281 mol). It should be noted that, yield of the product from 5-norbornene-2-sulfonyl chloride was 38.1%.

1. customInto a three-necked flask having
2. customan inner volume of 3 L equipped with a stirrer
3. additionwas poured
4. additionadded dropwise to the reaction system so that the inner temperature of the reaction system
5. temperaturewas maintained in a range of 11 to 15° C
6. temperatureAfter that, the inner temperature was raised up to 50 to 53° C.
7. temperatureby heating
8. customcontained in another dropping funnel
9. additionwas added dropwise to the reaction system over 3 hours
10. temperaturethe inner temperature of the reaction system was also maintained at around 50° C
11. customthe reaction liquid
12. temperatureAfter cooling down
13. customthe reaction liquid to 15° C.
14. custompH of the reaction liquid at 7.3 so that the inner temperature of the reaction system
15. temperaturewas maintained in a range of 15 to 17° C
16. customThe reaction liquid
17. extractionwas extracted with ethyl acetate (900 g) twice
18. washwashed with water (200 g)
19. concentrationconcentrated under the reduced pressure until the amount of the liquid
20. additionIsopropyl ether (103.7 g) was added to the resultant
21. concentrationconcentrated liquid in a heated state at 50° C.
22. customthe reaction liquid
23. temperaturewas cooled down to 5° C. at a rate of about 10° C./hour
24. customto precipitate crystal of the product
25. filtrationAfter filtering the precipitated crystal
26. filtrationthe filtered out crystal
27. washwas washed with isopropyl ether (50 g) at 5° C.
28. customdried at 40° C. for 2 hours under the reduced pressure

ORD record

ord-96cc2f16567d484f8d780316b1830d58

Source dataset

uspto-grants-2013_02

DOI

10.6084/m9.figshare.5104873.v1

Patent number

US08367849B2