홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Hydrochloric Acid → 6-Hydroxybuspirone

HRID 2182752
인쇄

반응식

HRID 2182752 반응식
[N:1]1[CH:6]=[CH:5][CH:4]=[N:3][C:2]=1[N:7]1[CH2:12][CH2:11][N:10]([CH2:13][CH2:14][CH2:15][CH2:16][N:17]2[C:26](=[O:27])[CH2:25][C:20]3([CH2:24][CH2:23][CH2:22][CH2:21]3)[CH2:19][C:18]2=[O:28])[CH2:9][CH2:8]1.P(OCC)(OCC)[O:30]CC.C[Si]([N-][Si](C)(C)C)(C)C.[Na+].C(OC)(C)(C)C.Cl>C1COCC1>[CH:5]1[CH:6]=[N:1][C:2]([N:7]2[CH2:12][CH2:11][N:10]([CH2:13][CH2:14][CH2:15][CH2:16][N:17]3[C:26](=[O:27])[CH:25]([OH:30])[C:20]4([CH2:24][CH2:23][CH2:22][CH2:21]4)[CH2:19][C:18]3=[O:28])[CH2:9][CH2:8]2)=[N:3][CH:4]=1
참가 물질실험 절차후처리출처 및 근거반응 노트

참가 물질

7

반응물 5

HCID 313Hydrochloric Acid2회HCID 2477Buspirone5회HCID 15413tert-Butyl methyl etherHCID 31215Triethyl phosphiteHCID 2724254Sodium bis(trimethylsilyl)amide2회

생성물 1

HCID 99309136-Hydroxybuspirone수율 85.7%

시약·촉매·용매 1

HCID 8028Tetrahydrofuran용매3회

실험 절차

Buspirone (8-[4-[4-(2-pyrimidinyl)-1-piperazinyl]butyl]-8-azaspiro(4.5)-decane-7,9-dione) (246.5 g, 639.6 mmol) was charged to a 12 L flask equipped with a mechanical stirrer and a React-IR probe under inert gas. Tetrahydrofuran (4.383 kg, 60.8 mol, 4.930 L, 20 mL/g) was charged and the mixture agitated at ambient temperature until homogeneous. Triethyl phosphite (371.9 g, 2.238 mol, 383.8 mL, 3.5 eq) was added and the mixture was cooled to −68 to −75° C. The mixture was agitated at this temperature for at least 10 minutes to allow the React-IR signal to stabilize. 1.0 M Sodium bis(trimethylsilyl)amide in THF (600.4 g, 664.1 mmol, 664.1 mL, 1.00 eq) was charged to the mixture at such a rate so as to maintain the temperature less than −60° C. Small amounts of sodium bis(trimethylsilyl)amide were charged to the mixture until the IR signal for buspirone reached a minimum indicating complete deprotonation of buspirone. Additional buspirone in THF (10-20 mL/g) was then charged to the reaction mixture in small increments until the IR signal indicated a 0.5% to 5% excess of buspirone. Air was sparged into the reaction mixture, controlling the initial rate of sparging so as to maintain the temperature of the reaction mixture less than −60° C. The sparging was continued until the reaction was complete as indicated by HPLC. Methyl tert-butyl ether (384.8 g, 4.365 mol, 520.0 mL) was added followed by 1M hydrochloric acid (1350.8 g, 1.328 mmol, 1328 mL) and the solution was warmed to ambient temperature. The pH was adjusted to between 6.5 and 6.9 using hydrochloric acid and Na3PO4. The phases were separated and the organic phase was washed twice with brine (542.3 g, 493 mL). The solvent of the rich organic layer was then replaced by isopropyl alcohol and the solution was cooled to crystallize the reaction product. There is an option to seed with 0.01 to 5% buspirone at approximately 54 to 56° C. The crystalline slurry was then filtered and the wet cake was washed with isopropyl alcohol and dried to provide 6-hydroxybuspirone (220.0 g, 82%), mp 109.5° C.

후처리

  1. customequipped with a mechanical stirrer
  2. temperaturethe mixture was cooled to −68 to −75° C
  3. stirringThe mixture was agitated at this temperature for at least 10 minutes
  4. temperatureto maintain the temperature less than −60° C
  5. customAir was sparged into the reaction mixture
  6. customof sparging so as
  7. temperatureto maintain the temperature of the reaction mixture less than −60° C
  8. temperaturethe solution was warmed to ambient temperature
  9. customThe phases were separated
  10. washthe organic phase was washed twice with brine (542.3 g, 493 mL)
  11. temperaturethe solution was cooled
  12. customto crystallize the reaction product
  13. customat approximately 54 to 56° C
  14. filtrationThe crystalline slurry was then filtered
  15. washthe wet cake was washed with isopropyl alcohol
  16. customdried

출처 및 근거

ORD 기록
ord-2cdda9353a9d46658e1760983e7459dd
출처 데이터셋
uspto-grants-2005_05
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06897309B2

반응 노트

이 페이지에서참가 물질실험 절차후처리출처 및 근거반응 노트