홈MCP워크벤치Skills
홈워크벤치알림마이페이지
llms.txt · MCP 가이드개인정보처리방침 · 이용약관 · 지원v1.8.3
  1. 홈
  2. /반응

Hydrochloric Acid → 5-Fluoro-2-mercaptobenzoic acid

HRID 990912
인쇄

반응식

HRID 990912 반응식
[S-2:1].[Na+].[Na+].[S].[OH-].[Na+].[F:7][C:8]1[CH:16]=[C:12]([C:13]([OH:15])=[O:14])[C:11](N)=[CH:10][CH:9]=1.Cl.N([O-])=O.[Na+].N([O-])=O>O>[F:7][C:8]1[CH:16]=[C:12]([C:13]([OH:15])=[O:14])[C:11]([SH:1])=[CH:10][CH:9]=1
참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트

참가 물질

9

반응물 7

HCID 313Hydrochloric Acid2회HCID 946NitriteHCID 14798Sodium HydroxideHCID 14804Sodium SulfideHCID 1014122-Amino-5-fluorobenzoic acidHCID 5362487SulfurHCID 23668193Sodium Nitrite

생성물 1

HCID 2783371
5-Fluoro-2-mercaptobenzoic acid

시약·촉매·용매 1

HCID 962Water용매4회

반응 조건

온도
6 °C

실험 절차

A mixture of crystallized sodium sulfide (1.8 g, 0.01 mole) and powdered sulfur (0.24 g) was dissolved by heating and stirring in 2 cc of boiled water. A solution of 0.3 g of sodium hydroxide in 1 cc of water was then added and the mixture was cooled stepwise as detailed above. Four cc of water, 1 g (0.007 mole) of 5-fluoro-anthranilic acid and 1.4 cc of concentrated hydrochloric acid were added to a separate beaker which was set by a freezing mixture to 0° C. The mixture was stirred and cooled to about 6° C. Meanwhile, 0.48 g (0.007 mole) of sodium nitrite were dissolved in 2 cc of hot water and the solution was cooled on ice. When the temperature dropped to 5° C., the nitrite solution was run through a separatory funnel into the anthranilic solution. About 3.5 g of cracked ice were added at a rate that kept temperature below 5° C. The diazo solution was then added to the alkaline sulfide solution (which was kept at a temperature of 2°-4° C.) along with 10 g of ice and temperature was kept below 5° C. The mixture was allowed to warm up to room temperature, and when evolution of nitrogen ceased (about 2 h), concentrated hydrochloric acid (˜1.5 cc) was added until the solution was acid to Congo red paper. The precipitate of disulfide was filtered and washed with water. To remove the excess sulfur, the precipitate was dissolved by boiling with a solution of 0.5 g of anhydrous sodium carbonate in 15 cc of water and the mixture was filtered while hot. The solution was then acidified with hydrochloric acid, the precipitate was filtered and the cake was sucked to dryness. The cake was dried by addition of toluene followed by azeothropic evaporation. This procedure was repeated twice. The cake was mixed with 0.2 g of zinc dust and 2 cc of glacial acetic acid, and the mixture was refluxed for overnight. The mixture was cooled and filtered with suction. The filter cake was washed once with water and transferred to a 10 cc beaker. The cake was suspended in 2 cc of water and the suspension was heated to boiling. The hot solution was made strongly alkaline by the addition of about 0.3 cc of a 33% sodium hydroxide solution. The alkaline solution was boiled about 20 min. and the insoluble material was filtered. The product was then precipitated by the addition of concentrated hydrochloric acid to make the solution acid to Congo red paper. The product was filtered with suction, washed once with water, and dried in an oven at 100°-130° C.; mp was 185° C.

후처리

  1. dissolutionwas dissolved
  2. temperatureby heating
  3. temperaturethe mixture was cooled stepwise
  4. customwas set by a freezing mixture to 0° C
  5. temperaturethe solution was cooled on ice
  6. additionWhen the temperature dropped to 5° C.
  7. customtemperature below 5° C
  8. customwas kept at a temperature of 2°-4° C.
  9. customwas kept below 5° C
  10. temperatureto warm up to room temperature
  11. additionwas added until the solution
  12. filtrationThe precipitate of disulfide was filtered
  13. washwashed with water
  14. customTo remove the excess sulfur
  15. dissolutionthe precipitate was dissolved
  16. filtrationthe mixture was filtered while hot
  17. filtrationthe precipitate was filtered
  18. dry with materialThe cake was dried by addition of toluene
  19. customfollowed by azeothropic evaporation
  20. additionThe cake was mixed with 0.2 g of zinc dust and 2 cc of glacial acetic acid
  21. temperaturethe mixture was refluxed for overnight
  22. temperatureThe mixture was cooled
  23. filtrationfiltered with suction
  24. washThe filter cake was washed once with water
  25. temperaturethe suspension was heated to boiling
  26. additionby the addition of about 0.3 cc of a 33% sodium hydroxide solution
  27. filtrationthe insoluble material was filtered
  28. customThe product was then precipitated by the addition of concentrated hydrochloric acid
  29. filtrationThe product was filtered with suction
  30. washwashed once with water
  31. customdried in an oven at 100°-130° C.

출처 및 근거

ORD 기록
ord-5139f438f43842fc94d9d3a7504829b2
출처 데이터셋
uspto-grants-2002_10
DOI
10.6084/m9.figshare.5104873.v1
특허 번호
US06462086B1

반응 노트

이 페이지에서참가 물질반응 조건실험 절차후처리출처 및 근거반응 노트